standing wave ratio वाक्य
उदाहरण वाक्य
मोबाइल
- Many different methods can be used to measure standing wave ratio.
- There is a relationship between the measures of reflection coefficient and standing wave ratio.
- Slotted lines are primarily intended for measurement of the voltage standing wave ratio on the line.
- Where VSWR is the standing wave ratio expressed as a voltage ratio ( not in decibels ).
- An important measure of this basic concept is the standing wave ratio, which measures the magnitude of the reflected signal.
- A controlled cable characteristic impedance is important because the source and load impedance should be maximum power transfer and minimum standing wave ratio.
- Further specifications are the LNA's operating bandwidth, gain flatness, stability, input and output voltage standing wave ratio ( VSWR ).
- The degree to which the wave resembles either a pure standing wave or a pure traveling wave is measured by the standing wave ratio ( SWR ).
- The term " power standing wave ratio " ( PSWR ) is sometimes referred to, and defined as the square of the voltage standing wave ratio.
- The term " power standing wave ratio " ( PSWR ) is sometimes referred to, and defined as the square of the voltage standing wave ratio.
- This causes standing waves on the transmission line ( a standing wave ratio ( SWR ) greater than one ) which waste energy, and can even overheat the transmitter.
- This is indicated by a finite standing wave ratio ( SWR ), the ratio of the amplitude of the wave at the antinode to the amplitude at the node.
- The gain relative to an isotropic antenna ( dBi ), front-to-back ratio, standing wave ratio and the general reception pattern are all evident from these numbers.
- This may be used to improve the standing wave ratio in order to minimize losses in the transmission line and to present the transmitter or receiver with a standard resistive impedance that it expects to see for optimum operation.
- This is most efficiently accomplished using a matching network at the site of the antenna, since simply adjusting a matching network at the transmitter ( or receiver ) would leave the transmission line with a poor standing wave ratio.
- The "'power standing wave ratio "'( "'PSWR "') is defined as the square of the VSWR, however this terminology has no physical relation to actual powers involved in transmission.
- The degree of mismatch between the feedline and the antenna is measured by an instrument called an SWR meter ( standing wave ratio meter ), which measures the " standing wave ratio " ( SWR ) on the line.
- The degree of mismatch between the feedline and the antenna is measured by an instrument called an SWR meter ( standing wave ratio meter ), which measures the " standing wave ratio " ( SWR ) on the line.
- If the array had a higher reactance value ( leading to a higher Standing wave ratio ) on one side of the frequency vs the other, it would affect the audio response of that channel and thus the stereo signal would be affected.
- This is especially important for transmitting antennas and their feed lines; high standing wave ratio on a radio or TV antenna can distort the signal, increase transmission line loss and potentially damage components in the transmission path, possibly even the transmitter.
- अधिक वाक्य: 1 2
standing wave ratio sentences in Hindi. What are the example sentences for standing wave ratio? standing wave ratio English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.